Thingiverse
Tolerance test Cubes
door Heisenberg_3D
0
Downloads
0
Likes
0
Makes
Tolerance test as said.
Hello, I'm new to Thingiverse and this is a test but if you want to tip me I'm fine lol
I wanted to know how my just unboxed P1P deals with tolerances, so I drawn this PIP to check its limits, basically with std parameters 0.2 layer height and 0.5 first layer so it could probably do even better. No auxiliary fan fyi, P1P as it hops out the box.
Tolerances are between the sphere and the inner wall of the cube, on the diameter.
The 0.35mm came out after some fiddling with a blade and many hits from every side, so one of the cube's pillars is cracked.
The 0.4mm should print in place correctly and need less knocks (better a constant pressure and some torsions) until it slightly snaps and rolls into its cubic cage! :)
Somehow satisfying.
...Gonna add the 0.3mm one as a challenge! Glad if someone shows me it's printable!
Hello, I'm new to Thingiverse and this is a test but if you want to tip me I'm fine lol
I wanted to know how my just unboxed P1P deals with tolerances, so I drawn this PIP to check its limits, basically with std parameters 0.2 layer height and 0.5 first layer so it could probably do even better. No auxiliary fan fyi, P1P as it hops out the box.
Tolerances are between the sphere and the inner wall of the cube, on the diameter.
The 0.35mm came out after some fiddling with a blade and many hits from every side, so one of the cube's pillars is cracked.
The 0.4mm should print in place correctly and need less knocks (better a constant pressure and some torsions) until it slightly snaps and rolls into its cubic cage! :)
Somehow satisfying.
...Gonna add the 0.3mm one as a challenge! Glad if someone shows me it's printable!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
