MakerWorld
Test Models
Go to Model
Tolerance Test (Long Version)
1.4k
Downloads
131
Likes
956
Makes
Tolerance Fitment Test - Long Version 0.05 to 0.40 mm tolerance test. Try insert the round and square pegs into each hole and see how good your printer's tolerances are. Note: Tolerances are for each mating surface. E.g. For 0.1mm, there is 0.1mm gap on all sides of the hole, and the holes are 10.2mm wide. Note: The pegs are 10mm wide. Short Version: https://makerworld.com/en/models/22224#profileId-20163
kvnper also publishes on
9 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
