Thingiverse
Tolerance test
door ilko
20
Downloads
11
Likes
0
Makes
**Understanding the tolerance**
It's an additional gap left while designing in order to make moving parts move freely and as smooth as possible without being too loose. It has to be considered as well for fitting objects into others.
**Application**
Let's say you want to slide a 10 mm cube (male) into another one, the amount of tolerance is applied once per side. That means if you leave 0.25 mm, it will be a total of 0.5 mm for each XY axis. The female cube will then measure 10.5 mm (horizontally).
**The object**
This print is a good to go for testing your machine's limits when you have parts that move or sliding pieces. The amount of tolerance is indicated on front and back. Divide the corresponding number by 100 to get millimeters.
**Ø 0.4 Recommended settings :**
Layer height : 0.25 mm
Walls : 3 (1.2 mm)
Infill : 10-20%
Speed : 60 mm/s
Print time : +2H
It's an additional gap left while designing in order to make moving parts move freely and as smooth as possible without being too loose. It has to be considered as well for fitting objects into others.
**Application**
Let's say you want to slide a 10 mm cube (male) into another one, the amount of tolerance is applied once per side. That means if you leave 0.25 mm, it will be a total of 0.5 mm for each XY axis. The female cube will then measure 10.5 mm (horizontally).
**The object**
This print is a good to go for testing your machine's limits when you have parts that move or sliding pieces. The amount of tolerance is indicated on front and back. Divide the corresponding number by 100 to get millimeters.
**Ø 0.4 Recommended settings :**
Layer height : 0.25 mm
Walls : 3 (1.2 mm)
Infill : 10-20%
Speed : 60 mm/s
Print time : +2H
ilko publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
