Thingiverse
Tool Holder
von poedba
3
Downloads
2
Likes
0
Makes
This Tool Holder is designed to hold 1 Spatula, 1 pair of Snips, and 2 Brushes (purchased from Harbor Freight).
To attach to printer...
1. Feed M3*8 bolts from front face through back offset mount. (You may need to screw the bolt through the back due to tight fit.)
2. Attach M3 T-Nuts.
3. Insert into V-Slot.
4. Tight to secure to Ender 3v2.
To attach to printer...
1. Feed M3*8 bolts from front face through back offset mount. (You may need to screw the bolt through the back due to tight fit.)
2. Attach M3 T-Nuts.
3. Insert into V-Slot.
4. Tight to secure to Ender 3v2.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
