Thingiverse
Tool Rack
von MakeConvenient
4
Downloads
34
Likes
0
Makes
The existing hardware prints didn't fit my tools. I wanted this inside my cabinet.
Seems to work with just M3 tape but I put in a bunch of screw holes in case you'd prefer to use M4 screws. M3 work on internal screws if the heads are too wide.
Happy printing. No supports. I ran PETG 25% infill.
Seems to work with just M3 tape but I put in a bunch of screw holes in case you'd prefer to use M4 screws. M3 work on internal screws if the heads are too wide.
Happy printing. No supports. I ran PETG 25% infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
