Toothbrush Holder

I designed this toothbrush holder for my own use, to stop people just leaving their toothbrushes around the bathroom bench. Grrr. The brushes are easy to grab and replace, so people actually used it :) Each toothbrush 'rack' is angled at about 5 degrees in oposite directions, so the head slopes down at opposite ends. It solves the problem with using a cup, whereby the toothbrush sits in a pool of spit, toothpaste and water, which is even more vile than leaving them all around my sink! You could stick it to the tiles with 3M tape, or similar, I was reusing the holes from a previously installed 'cup of spit', which is why I used screws. I printed min in PLA. Resin would be fine if you paint/seal it, but it is overkill! Toothbrushes not included.