Thingiverse
Toothpaste Dispenser
von DanielMitchell
1.8k
Downloads
2.1k
Likes
9
Makes
#Awesome Toothpaste Dispenser
This unique design/creation allows you to distribute toothpaste directly onto your toothbrush. It also acts as an additional toothbrush stand or holder.
• The toothpaste extruder can be locked in place to prevent tubes from rolling out.
• Additional toothbrush holders can be printed depending on the amount of users.
• The toothpaste extruder/roller can also be used separately as a portable version.
The design was printed and tested using Ultimaker Cura 3.6.0, with the following settings (PLA):
Base & Toothbrush Holders
layer height: 0.24
Infill: 35%
Supports: No
Stand
layer height: 0.20
Infill: 35%
Supports: Yes
Extruder & Extruder Shaft
layer height: 0.20
Infill: 35%
Supports: No
• The total print time can be expected at around 11 hours.
Don't forget to comment or like.
Thanks.
This unique design/creation allows you to distribute toothpaste directly onto your toothbrush. It also acts as an additional toothbrush stand or holder.
• The toothpaste extruder can be locked in place to prevent tubes from rolling out.
• Additional toothbrush holders can be printed depending on the amount of users.
• The toothpaste extruder/roller can also be used separately as a portable version.
The design was printed and tested using Ultimaker Cura 3.6.0, with the following settings (PLA):
Base & Toothbrush Holders
layer height: 0.24
Infill: 35%
Supports: No
Stand
layer height: 0.20
Infill: 35%
Supports: Yes
Extruder & Extruder Shaft
layer height: 0.20
Infill: 35%
Supports: No
• The total print time can be expected at around 11 hours.
Don't forget to comment or like.
Thanks.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
