Toothpaste Squeezer

Clean Up and Sand:Once the squeezer is printed, remove any support structures or excess material.Use sandpaper to smooth out any rough edges or imperfections. Start with a coarse grit (around 80-120) and gradually move to finer grits (up to 400 or higher) for a polished finish.Clean the squeezer thoroughly to remove any dust or debris.Prepare the Toothpaste Tube:Take your toothpaste tube (make sure it’s not a hard plastic one) and flatten the end slightly. You can do this by pressing it against a flat surface or using your fingers.Be gentle to avoid damaging the tube.Insert the Tube into the Squeezer:Locate the narrow slot in the squeezer. It should be designed to accommodate the flattened end of the toothpaste tube.Wiggle the end of the tube through the slot until it fits snugly. Depending on the tube’s material, you might need to apply a little pressure or wiggle it back and forth.Squeeze and Use:Pull the squeezer toward the full end of the tube as far as possible.As you use the toot