Thingiverse
Toothpick Base
by Zimlorog
22
Downloads
12
Likes
0
Makes
A small and simple component in two sizes—5mm & 8mm—to enhance the use of toothpicks for painting scale models; miniatures; or whatever else.
To use:
Cut off one point of a toothpick, then add a drop of super glue (or your preference) before inserting the toothpick.
**Note:
The hole is 2.5mm, if you're printer is prone to under-sizing prints, adjust the scale accordingly.**
**Caution:
When scraping these off of the build plate, place your hand over them so they don't fly off into the void!**
To use:
Cut off one point of a toothpick, then add a drop of super glue (or your preference) before inserting the toothpick.
**Note:
The hole is 2.5mm, if you're printer is prone to under-sizing prints, adjust the scale accordingly.**
**Caution:
When scraping these off of the build plate, place your hand over them so they don't fly off into the void!**
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
