Thingiverse
Toothpick Base
door Zimlorog
22
Downloads
12
Likes
0
Makes
A small and simple component in two sizes—5mm & 8mm—to enhance the use of toothpicks for painting scale models; miniatures; or whatever else.
To use:
Cut off one point of a toothpick, then add a drop of super glue (or your preference) before inserting the toothpick.
**Note:
The hole is 2.5mm, if you're printer is prone to under-sizing prints, adjust the scale accordingly.**
**Caution:
When scraping these off of the build plate, place your hand over them so they don't fly off into the void!**
To use:
Cut off one point of a toothpick, then add a drop of super glue (or your preference) before inserting the toothpick.
**Note:
The hole is 2.5mm, if you're printer is prone to under-sizing prints, adjust the scale accordingly.**
**Caution:
When scraping these off of the build plate, place your hand over them so they don't fly off into the void!**
Zimlorog publiceert ook op
9 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
