Thingiverse
Toothpick stand
von JanEriKKa
8
Downloads
6
Likes
0
Makes
Toothpick / Plackers stand that fits five standard Plackers.
The image shows the evolution of this work.
Version one (left) was too small.
Version two (middle) was large enough, but the angles made it hard to use.
Version three (right) is a completely new design. It is now large enough and holds the plackers in place and they are easy to insert correctly.
Files for version two and three included. (The blank versions are without letters.)
The image shows the evolution of this work.
Version one (left) was too small.
Version two (middle) was large enough, but the angles made it hard to use.
Version three (right) is a completely new design. It is now large enough and holds the plackers in place and they are easy to insert correctly.
Files for version two and three included. (The blank versions are without letters.)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!