Tower

I decided to "repair" a piece of classic cardboard wargame terrain that had seen better days before it spent a decade in a box.

To build one you need to print:
Two long sides with mounts
Two short sides
One tower level
One tower base
One top, mid and bottom bracket
Two spinny sides
One spinny spacer
One spinny through

Its a bit fiddly to get together but i first glued three sides into the top bracket, then i glued in the middle bracket, after that the fourth side and at last the bottom bracket.
Then all that was glued to the base, the level slid over the top and glued where it rests on the joist connector thingies.

I put the long sides outside of the shorter ones, this is rectangular, so you will need to be careful with putting the brackets in so you get the direction right.

Then the spinny bit was glued together, i use a small length of bbq skewer as an axle for it.

Ive provided a long side with no mount hole for ease of remixing if anyone is interested.

Des