Toy 3D printer

A toy 3D printer with working X, Y and Z axis. It also has a spool on the back. As dummy filament I used NinjaFlex TPU but you could also use a string instead. The size of the printer is 150x150x150 mm and was based on a Flashforge 3D printer design.

# Hardware
* 4 x M3x12 self tapping screw

The screws are used to connect the bottom to the top.

# Assembly
1. Glue the glass bed to the bed.
2. Glue the bed knobs to the bed.
3. Place the z axis and lead screw in the bottom piece of the printer.
4. Place the assembled bed in the z axis/lead screw.
5. Place the top piece of the printer on the bottom piece and screw them together from the bottom.
6. Place the x and y axis in the top piece
7. Place the printer head piece on the x and y axis and glue them together. Make sure you do no glue the x and y axis to the print head otherwise it will not be able to move freely.
8. Glue the corners to the side of the printer.
9. Snap the filament guide into place.
10. Snap the spool