Thingiverse
TP-LINK EAP Ceiling mount plate
por ahuck607
21
Descargas
15
Likes
0
Makes
Thought I'd share this - needed a mounting plate for an EAP225 v1/v2 and couldn't find anything so designed this based on the actual TP-Link Omada (v1/v2) mounting plate.
This is a ceiling / wall mounting plate for TP-Link Omada EAP series (EAP110, EAP115, EAP120, EAP225, EAP245) v1 and v2 - the Square Smooth shelled access point (see pictures) NOT the v3 "wavy" shelled ones.
It uses some of the same screw holes and the same twist install or remove method as the original, it also has spring clips like the original to make sure the Access point is securely held.
Fix to ceiling/wall with appropriate standard DIY fixings.
This needs to be printed on a raft standing up on its long edge or the "grain" of the print will cause it to fail when you put the Access point on (or maybe later over time). Printing on edge actually turned out to be a valid method and was not problematic for me.
Hope this helps someone out.
This is a ceiling / wall mounting plate for TP-Link Omada EAP series (EAP110, EAP115, EAP120, EAP225, EAP245) v1 and v2 - the Square Smooth shelled access point (see pictures) NOT the v3 "wavy" shelled ones.
It uses some of the same screw holes and the same twist install or remove method as the original, it also has spring clips like the original to make sure the Access point is securely held.
Fix to ceiling/wall with appropriate standard DIY fixings.
This needs to be printed on a raft standing up on its long edge or the "grain" of the print will cause it to fail when you put the Access point on (or maybe later over time). Printing on edge actually turned out to be a valid method and was not problematic for me.
Hope this helps someone out.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
