Thingiverse

Transformer Bracket + Stuff

door Khombhat

3 Downloads

6 Likes

0 Makes

EDIT: Okay so I re-worked the bracket and clip to fit the new bracket which now uses a threaded end design with nuts to lock the "clip" down to the base of the core. It works,but it isn't perfect. The nut threads print just fine because they print vertically. The bracket, however, is too thin to print vertically as it will snap when you apply enough force onto the clip via the nuts. As such, I have had to print the bracket laying down which greatly reduces the resolution of the threads because they are so small. Because of that, I have had to scale the nuts up by about 1.15 times. This might be a good print for a resin printer, but then the nuts might not actually fit the bracket anymore. If you find this to be true, let me know and I will see about providing an alternate design for that. If you have any suggestions, please let me know.

I designed this basic clipping bracket for the UY1658/60 U-Shaped 236mm ferrite transformer core. It turned out quite nicely, I think. I

bracket circuits clamp core diy electricity electronics flyback frame high voltage Jig jigs practical tool tools transformer Transformer core transformers useful bracket circuits clamp core diy electricity electronics flyback frame high voltage Jig jigs practical tool tools transformer Transformer core transformers useful

Bron

Thingiverse

Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid

Eendelig Hardware nodig

Supports 1/3

Montage 0/3

Instellingen 1/3

Bedgrootte 0/3

Nabewerking 1/3

Printer

FDM / FFF

Bestandsformaat