Thingiverse
Transparency Paper Shield Visor
von hernejj
12
Downloads
14
Likes
0
Makes
This is a visor for a face shield that can be made using the supplied 3d printed parts and overhead/inkjet transparencies. Since the rise of what is know as the COVID-19/Corona Virus, face shields are becoming quite scarce within the medical community. This design is an attempt to help fill this supply gap with cheap commonly available materials.
TEST PIECE: Print the test piece first to make sure the "gap" used to hold transparency paper prints open without being obstructed. Also print a few pegs to make sure they fit in the shield retention holes well, and stay in place.
INSTRUCTIONS:
1. Print out the frame (File name is face-shield-frame-v2.stl) and four pegs.
2. You *may* need to use an x-acto knife to gently cut/snap any very slightly fused plastic in the gaps that hold the transparency in place.
3. Insert a piece of 8.5x11 or A4 transparency paper into the frame slots. Use a marker to mark where the holes in the arms of the frame line up with the transparency.
TEST PIECE: Print the test piece first to make sure the "gap" used to hold transparency paper prints open without being obstructed. Also print a few pegs to make sure they fit in the shield retention holes well, and stay in place.
INSTRUCTIONS:
1. Print out the frame (File name is face-shield-frame-v2.stl) and four pegs.
2. You *may* need to use an x-acto knife to gently cut/snap any very slightly fused plastic in the gaps that hold the transparency in place.
3. Insert a piece of 8.5x11 or A4 transparency paper into the frame slots. Use a marker to mark where the holes in the arms of the frame line up with the transparency.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
