Thingiverse
Transparency Test
door Raycekar
1
Downloads
0
Likes
0
Makes
This is the Transparency Test to test the transparency of your filament. I used this when creating a screen for my Hestiapi Thermostat out of filament that was too bright during the night. This was designed to be small enough to save on filament.
Each square is 5mm x 5mm and the height starts at 0.2 mm and goes up to 2mm in increments of 0.2mm.
Each square is 5mm x 5mm and the height starts at 0.2 mm and goes up to 2mm in increments of 0.2mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
