Transparency tower - Test vertical transparency

I made this tower to test transparency in different filaments on the vertical plane and not on the horizontal plane as most tests do - Like the OG lithography. If you want to test for twice the thickness just add the lightsource behind the tower. If you want half the value then add the lightsource inside the tower. It is calibrated to work with 0.4 mm nozzle. Make sure to set outlines to 10% and no infill. Also change “Line width” to 0.4 mm on all perameters. Unless you want to try with smaller nozzles then some walls will just not get printed. If you want to save a little filament you can set the Z height lower as long as you turn of "uniform scaling".