Triangle bracelet

This was an attempt to build a chain that does not require supports. The links are built at a 45 degree angle so that most printers can print them without supports. I did find it fairly difficult to print. There are 24 links in the chain and during most of the print there are 48 separate pieces being printed. It is very easy for one of them to break loose.
I do not recommend scaling it down very much. It needs as much surface area as possible to adhere to the build surface.

I am open to suggestions on how to improve it. I was thinking of adding extra pieces to the base to make them stick better, but I thought that it might make it look worse.