Thingiverse
Triangular edge paving brick mold
by Stockpiles
22
Downloads
16
Likes
0
Makes
Needed bricks and was too cheap to buy them.
Printed this in 95A TPU at 35% infill.
Print at a larger layer height since a lot of the finer details come off then removing the brick from the mold.
I used a soap and water solution to help the concrete release from the mold but it may not actually be needed.
Printed this in 95A TPU at 35% infill.
Print at a larger layer height since a lot of the finer details come off then removing the brick from the mold.
I used a soap and water solution to help the concrete release from the mold but it may not actually be needed.
Stockpiles also publishes on
12 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
