Thingiverse
Triangular edge paving brick mold
von Stockpiles
22
Downloads
16
Likes
0
Makes
Needed bricks and was too cheap to buy them.
Printed this in 95A TPU at 35% infill.
Print at a larger layer height since a lot of the finer details come off then removing the brick from the mold.
I used a soap and water solution to help the concrete release from the mold but it may not actually be needed.
Printed this in 95A TPU at 35% infill.
Print at a larger layer height since a lot of the finer details come off then removing the brick from the mold.
I used a soap and water solution to help the concrete release from the mold but it may not actually be needed.
Stockpiles veröffentlicht auch auf
12 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
