TriGorilla Case for Hypercube

I wanted to house my TriGorilla MOSFET and make it look clean for the Hypercube 300 build https://www.thingiverse.com/thing:2517628. To make things easy I used a 40mm fan and tied it into the control side wiring. A few holes were added to allow cables to pass through. The power supply case sits next to it so the wiring is minimal. The power supply case was made from the Hypercube accessory pack https://www.thingiverse.com/thing:2084725. Let me know if there is anything that I could improve on.