Trimui Brick Case

A hinged case for the Trimui Brick, with access to the charging port. Designed to be a snug fit to prevent it rattling around, while also being easy to remove. To keep the case as slim as possible, I've opted for a pressure fit style closing mechanism. This design means it's also extremely unlikely to pop open on it's own, but is easy to open when you want. Prints perfectly without supports, and should be printed with the seam at the rear - next to the hinges. Requires two M3 screws, somewhere between 20 and 30mm long. I've designed the screw holes to extend pretty far into the rear of the case to allow for some variation in screw length. I've been printing and selling these on Etsy for a while so the design is tested, but if you run into any issues with the print please reach out! I'm happy to help with any printing issues you might run into. I've uploaded two versions, both identical with the exception of the front design. One has the button and screen lay