TrimUI Brick Case

This is a protective case for the TrimUI Brick. There is no additional hardware required for assembly like screws. However, the piece of protective foam that came with the TrimUI Brick is needed. There are four designs: Two that feature an illustration of the TrimUI Brick itself. On of those two also has the design on the sides. I reccomend printing that one only on the H2D, as the design on the side would waste a lot of material when printed with a single nozzle setup. There is also a Zelda design and a single colour option.All designs, except for the single colour, feature my logo on the bottom halve. If you do not like to have my design on you print: You can set the logo colour to the colour of the body within the print window.AssemblyConnect the hinges from the lid to the case. Do not use too much force, the pieces are delicate and can break. If you use minimal force, but apply it consistently the hinges will connect.Place the protective foam in the lid. Pay atention to its orienta