Slicer Discord
Trophy – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Trophy

von Timprints · Decor
9 Downloads
6 Likes
0 Makes
Zum Modell
Hello. This is your average generic trophy. There is nothing special about this trophy. There is no reason you would use this trophy. This is just a trophy. There is no good reason why you should use this trophy. But you can still make this trophy. I did not make this trophy. I did not design this trophy. There is no good reason to put this trophy on Maker World. Why? Because I wanted to. Scratch that I actually couldn't think of a single reason to put this on. No personal or logical reason. That's it. P.S. SAVE THE PANGOLINS!Boost MeThere is no good reason to boost me.
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen