Thingiverse
TS101 stand
von JustinX
57
Downloads
82
Likes
0
Makes
Stand for a TS101 soldering iron.
Compared to the original, I made a cutout in the shelf so that the TS101 with its roll protection fits in.
Then I enlarged the compartment for the brass sponge so that it would fit with a diameter of 50mm.
Additionally, I made the holder solid without having to glue the base plate.
printed with ABS Carbon filament
1x M8x25x2 washer
1x M12x30x2 washer
Compared to the original, I made a cutout in the shelf so that the TS101 with its roll protection fits in.
Then I enlarged the compartment for the brass sponge so that it would fit with a diameter of 50mm.
Additionally, I made the holder solid without having to glue the base plate.
printed with ABS Carbon filament
1x M8x25x2 washer
1x M12x30x2 washer
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
