TTP Cooler

Took the stock Fan Duct for the TTP and added 5015 fans on each side with upgraded cooling

**v1 - Walls to thin and easily breakable. Also lots of uneven and harsh areas.Also duct was way too low

**v2 - Beefed up and smoothed out design, raised duct area up

**v3 Had to adjust vents more and Fan mount hole had to be moved further back

**v4 Ducts were too small. Enlarged the bottom part of the ducts and tweaked a few other little things

**V5 - Revised the bottom section completely. As cool as it looked it was hard to see your print, whille printing. So i revised the whole bottom section, vents, and changed the sides a little more