Thingiverse
Turntable
door CandidQuality
5
Downloads
8
Likes
0
Makes
Adjusted for a larger bearing I just happen to have an excess of.
These now fit a [6201zz bearing](https://amzn.to/3BIpuh3)
12mm id
10mm wide
32mm od
These are a deep groove bearing, so as long as your tolerances are good, will support itself well. I allowed some gap fit in the tolerance, so you should be able to install then use a glue or a thin piece of paper if needed to keep it in place.
matches up to [this bearing I uploaded for testing](https://www.thingiverse.com/thing:6168256), but I would not recommend actually printing that and thinking it would spin.
These now fit a [6201zz bearing](https://amzn.to/3BIpuh3)
12mm id
10mm wide
32mm od
These are a deep groove bearing, so as long as your tolerances are good, will support itself well. I allowed some gap fit in the tolerance, so you should be able to install then use a glue or a thin piece of paper if needed to keep it in place.
matches up to [this bearing I uploaded for testing](https://www.thingiverse.com/thing:6168256), but I would not recommend actually printing that and thinking it would spin.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
