Thingiverse
Turntable
por CandidQuality
5
Descargas
8
Likes
0
Makes
Adjusted for a larger bearing I just happen to have an excess of.
These now fit a [6201zz bearing](https://amzn.to/3BIpuh3)
12mm id
10mm wide
32mm od
These are a deep groove bearing, so as long as your tolerances are good, will support itself well. I allowed some gap fit in the tolerance, so you should be able to install then use a glue or a thin piece of paper if needed to keep it in place.
matches up to [this bearing I uploaded for testing](https://www.thingiverse.com/thing:6168256), but I would not recommend actually printing that and thinking it would spin.
These now fit a [6201zz bearing](https://amzn.to/3BIpuh3)
12mm id
10mm wide
32mm od
These are a deep groove bearing, so as long as your tolerances are good, will support itself well. I allowed some gap fit in the tolerance, so you should be able to install then use a glue or a thin piece of paper if needed to keep it in place.
matches up to [this bearing I uploaded for testing](https://www.thingiverse.com/thing:6168256), but I would not recommend actually printing that and thinking it would spin.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
