Thingiverse
TUSH Lite
door giacomo1574
0
Downloads
2
Likes
0
Makes
I remixed The Ultimate Spool Holder to:
- Fit four bearings i had laying around which were differently sized
- Use way less plastic
- You can now fit a M6 threaded rod to space them correctly, make the structure sturdier and you can also apply a little convergence so that the spool doesn't roll off
- There is a version of the spool holder which uses two small tabs that prevent the spool from rolling off.
I will post the .f3d later so it's even more customizable
- Fit four bearings i had laying around which were differently sized
- Use way less plastic
- You can now fit a M6 threaded rod to space them correctly, make the structure sturdier and you can also apply a little convergence so that the spool doesn't roll off
- There is a version of the spool holder which uses two small tabs that prevent the spool from rolling off.
I will post the .f3d later so it's even more customizable
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
