Twisted Cube Impossible Box

I've only printed this once when my printer was going through some heating and calibration issues, but it still came out decent and functional. I'm sure if your printer is dialed in it would print out great. I used a 0.4mm nozzle. I would love to see some one print it with a 0.1mm. It prints in place and the interior ball spins. I wouldn't use a raft, and I didn't print with any supports.

EDIT: I just tried to print this at 0.1mm with a 0.4mm nozzle but ran into adhesiveness issues. I'm now printing with a brim support only and it seams to working fine. Still have the gap so everything will spin once finished, just minor clean up after. Hope this helps.