Thingiverse
Twisted Vase
von SunnyRocketLove
0
Downloads
0
Likes
0
Makes
This is my first design, created with blender.
Printing Instructions:
Spiral vase mode
Layer height : 0,20mm PLA )
No supports needed
For the extrusion setting, I set the outer perimeter setting to 0,8mm to thicken the wall of the vase.
Printing Instructions:
Spiral vase mode
Layer height : 0,20mm PLA )
No supports needed
For the extrusion setting, I set the outer perimeter setting to 0,8mm to thicken the wall of the vase.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
