Thingiverse
Two-part try square
door NilsR
14
Downloads
10
Likes
0
Makes
You will need two M3x12 screws or similar to assemble. The maximum size is M3x16.
Make sure you print at a fine layer height and slow the outer shells down to make the edges more square.
Make sure you print at a fine layer height and slow the outer shells down to make the edges more square.
NilsR publiceert ook op
15 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
