Thingiverse
Two Tailed Fox
von kad
17
Downloads
11
Likes
0
Makes
A remix of schlossbauer's "Fox" into a two tailed fox for use in my D&D campaign.
I scaled it down to 60% to print. If you are using Cura I recommend getting a custom support addon and setting custom supports under the tails and chin. Cura dose not properly support either at the 60% scale.
I scaled it down to 60% to print. If you are using Cura I recommend getting a custom support addon and setting custom supports under the tails and chin. Cura dose not properly support either at the 60% scale.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
