Thingiverse
TX200 trigger guard
by jonnyg30
4
Downloads
4
Likes
0
Makes
As the name suggests, this is a trigger guard for the air arms TX200.
supports are needed, layer height is your choice. I's a good, no fouling of the trigger or anything like that, but I did notice the screw holes are slightly out, which makes it little awkward to get the screws in. Not enough of an issue for me to change the design, i just opened the holes a little more with the drill. you could possibly use a 1mm increase in length if it bothers you.
supports are needed, layer height is your choice. I's a good, no fouling of the trigger or anything like that, but I did notice the screw holes are slightly out, which makes it little awkward to get the screws in. Not enough of an issue for me to change the design, i just opened the holes a little more with the drill. you could possibly use a 1mm increase in length if it bothers you.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
