Thingiverse
U-Joint
von tmlowe
5
Downloads
4
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/fZkMbOmplIO
REQUIRES SUPPORT MATERIAL.
Printed as one piece, no post manufacturing.
8mm shaft holes on either end.
hasn't been tested yet, so not sure about range of motion.
NOW AVAILABLE: Sturdier output shaft that isn't suspended in the air.
REQUIRES SUPPORT MATERIAL.
Printed as one piece, no post manufacturing.
8mm shaft holes on either end.
hasn't been tested yet, so not sure about range of motion.
NOW AVAILABLE: Sturdier output shaft that isn't suspended in the air.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!