Thingiverse
Ultimate64 Power Button Bracket
door crashmeplease
31
Downloads
23
Likes
1
Makes
A power button and dc jack bracket to cover the side of the commodore 64c case when using an Ultimate64 board.
When fitting the braket, first place on the PCB with the button in place and around the dc jack, then slide the PCB into position.
This bracket works for me in my situation, A lot of time is required to clean up the print. I do not have original case screws but the parts should work with any similar sized screws.
When fitting the braket, first place on the PCB with the button in place and around the dc jack, then slide the PCB into position.
This bracket works for me in my situation, A lot of time is required to clean up the print. I do not have original case screws but the parts should work with any similar sized screws.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!