Universal Adjustable Kickstand

von BoringBit · Decor

46 Downloads

9 Likes

40 Makes

This is a small and filament-efficient kickstand for pictures, frames and notebooks. Tilt angle is fully customizable with a 3-part design, which you can assemble in 4 steps:Snap the bracket to the kickstand body. Make sure the notch is facing upward.Slide the leg through the notch following the direction of the arrow in the leg.Adjust the tilt. Ensure the leg's cog is not yet locked to the bracket's teeth.Lock the leg's cog to the bracket by sliding it into the bracket's teeth.The last animation in this listing shows the installation process. An alternative print profile with thicker body is also available. Use this for heavier stuff :)

kickstand picture picture art picture 3d picture stand picture frame stand notebook stand frame stand adjustable stand adjustable picture adjustable kickstand easel easel stand art easel hueforge stand hueforge holder picture holder photo stand photo holder

Kategorie

Decor

Quelle

MakerWorld

Veröffentlicht

21.01.2026

Aktualisiert

07.05.2026

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat

STL

Material

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Universal Adjustable Kickstand

Ähnliche Modelle

Zur Sammlung hinzufügen