Thingiverse
Universal Amp Stand
von JB_makes
72
Downloads
50
Likes
1
Makes
Simple guitar amplifier stand. 3 parts, must print the 2 legs and attach with two, 20mm M3 bolts and nuts. Depending on the material you print with, you may or may not have to press the nuts into place. I super-glued mine.
The maximum width the stand spans is around 15 cm at the top of the arms, and shown above I have a Fender Mustang amp that measures 21cm x 37cm x 34cm (depth, width, height) and fits perfectly with a tilt of around 15-20 degrees.
The maximum width the stand spans is around 15 cm at the top of the arms, and shown above I have a Fender Mustang amp that measures 21cm x 37cm x 34cm (depth, width, height) and fits perfectly with a tilt of around 15-20 degrees.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
