MakerWorld
Organizers
Model downloaden
Universal Cable Guide
6
Downloads
1
Likes
1
Makes
A simple universal cable holder mountable underneath a wooden table of sorts.It uses a 2 mm wide nail to hold it in place. I recommend you also print out the hammer extension if you cannot reach the hole for the nail.I printed in PLA at 100% for both.If you're having a hard time, I recommend using double-sided tape to hold in place.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
