Universal holder

Universal holder which I use with PCB. This is almost fully printable stand, except aluminium extrusion 2020 and rubber 14 mm stand which you need to buy. Depend on you need you can use 2020 with any available length.

Parts required in basic configuration (all are symmetric, no need to print left or right version):

01_Holder.stl (2 pcs)
02_Knob_M10.stl (2 pcs)
03_Slider.stl (2 pcs)
04_Stand.stl (2 pcs)
05_Small_Nut_M6.stl (2 pcs)
06_Knob_M6.stl (1 pcs)
07_Big_Nut_M6.stl (1 pcs)
08_Hammer_Bolt_L11.stl (2 pcs)
09_Hammer_Bolt_L15.stl (1 pcs)

Design contain additional 11_Slim_Slider.stl which I use to hold solder spool. It required 10_Sleeve.stl and 7_Big_Nut_M6.stl and metal bolt with any length you need. This extra slider required also metal bolt and hummer nut.

All part print with 0.2mm layer height, 3 perimeters and min 30% infill. Increase infill and perimeters for all elements with thread. Hummer bolt and nuts I recommend to print with 100% infill.

All parts a