Universal table saw outfeed system

Adjustable and portable table saw outfeed system Do you own a contractor saw? Do you have an outfeed table for your saw?  This model is for a complete outfeed system. It is modular, adaptable, adjustable and portable. It is also quick to assemble and remove.   Outfeed system Have you ever seen an outfeed system for a contractor saw? They are common for cabinet saws but these fixed, costly and they take up lots of floor space.  I have yet to see a portable one for contractor saws. What do you do to cut long pieces of wood or moldings? Do you ask your spouse or hope to find a helper? I often find myself this in situation and I am certain many are like me. I tried using a stand with a roller but often got frustrated. Unless I got the plane and height nailed down it would tip, move or cause my cut to veer off course. Usually, I would cross my fingers and either put a lot of pressure on the infeed side or stop halfway through the cut and lean or rush to grab the outfeed side. I was lucky. I only ended up with burn marks, uneven cuts or ruining the workpiece but I risked kickback or a more serious injury.   I set about designing an outfeed table system for contractor saws. The system had to offer the following: Adaptable to the different makes of contractors table saws that are sold.  Lightweight and portable; Easy and quick to install and remove; Adjustable in height, slope and adaptable to multiples environments (uneven floors, uneven heights, etc.) Affordable. The design The adaptability issue was somewhat of a challenge as most contractor saw fences latch at the front and back of the table and you cannot simply screw a hinge to the back of the table. My solution uses side brackets to which is attached a board and hinges. My design is adaptable to most contractor table saws: It can be easily retrofitted to existing contractor table saws It can be adjusted for different thicknesses of outfeed boards; You can adjust the slope, height and distance of the outfeed support a