Thingiverse
Up mini cooling system
par 3DO2
31
Téléchargements
22
Likes
1
Makes
This whole new extruder head design can prevent the ticking noise during PLA printing and also can prevent the overheating of the feeder motor at long term ABS prints. I designed two extra inlets as well where the secondary filament and bearing cooling is possible by compressed air.
The mod kind of effective(PLA) and also badass
(I also use a temp mod for the printer.)
Tested with ICE Black PLA and Faberdashery transparent blue PLA
A high rpm vent is advisable, to the side of the cooling case
(!!! the long term PLA prints still risky but much more better than without the mod.!!!)
extra parts that is need.
-2.5 EH CONNECTOR 3-Pin JST plug ( Male, Female, Crimps )
- 12V DC 40mm 20mm 2 Wire High rpm fan
-6 X 3 mm magnets (4 pieces) for the PCB board cover.
The mod kind of effective(PLA) and also badass
(I also use a temp mod for the printer.)
Tested with ICE Black PLA and Faberdashery transparent blue PLA
A high rpm vent is advisable, to the side of the cooling case
(!!! the long term PLA prints still risky but much more better than without the mod.!!!)
extra parts that is need.
-2.5 EH CONNECTOR 3-Pin JST plug ( Male, Female, Crimps )
- 12V DC 40mm 20mm 2 Wire High rpm fan
-6 X 3 mm magnets (4 pieces) for the PCB board cover.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
