Thingiverse
USB Cable Holder
von rmoro
41
Downloads
28
Likes
0
Makes
After printing the [USB Cable Holder](https://www.thingiverse.com/thing:3022893) designed by [Jules](https://www.thingiverse.com/JKB007/about) it turned out that the connector of an iPhone falls though the holes. I made three changes to his design:
- closed the sides of the holes (last 3 mm);
- made the first three entries to the hole 1 mm smaller;
- added 0.5 mm to the space of the screw head so it can sink in.
- closed the sides of the holes (last 3 mm);
- made the first three entries to the hole 1 mm smaller;
- added 0.5 mm to the space of the screw head so it can sink in.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
