Thingiverse
USB camera stand
by rob2000000
0
Downloads
0
Likes
0
Makes
120 mm tall camera stand for most types of monitor top USB cameras.
Added an adjustable height version giving 145,155 and 165mm heights
There is a fourth hole which can't be used on mine - it fell over - would give 175mm height
The screw is very tight and could benefit from being scaled on x and y to around 97% (or just file the thread or just use a piece of dowel)
Be sure to use a wide brim - the tall tower fell over on mine with around 20mm to go.
Added an adjustable height version giving 145,155 and 165mm heights
There is a fourth hole which can't be used on mine - it fell over - would give 175mm height
The screw is very tight and could benefit from being scaled on x and y to around 97% (or just file the thread or just use a piece of dowel)
Be sure to use a wide brim - the tall tower fell over on mine with around 20mm to go.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
