Thingiverse
USB camera stand
von rob2000000
0
Downloads
0
Likes
0
Makes
120 mm tall camera stand for most types of monitor top USB cameras.
Added an adjustable height version giving 145,155 and 165mm heights
There is a fourth hole which can't be used on mine - it fell over - would give 175mm height
The screw is very tight and could benefit from being scaled on x and y to around 97% (or just file the thread or just use a piece of dowel)
Be sure to use a wide brim - the tall tower fell over on mine with around 20mm to go.
Added an adjustable height version giving 145,155 and 165mm heights
There is a fourth hole which can't be used on mine - it fell over - would give 175mm height
The screw is very tight and could benefit from being scaled on x and y to around 97% (or just file the thread or just use a piece of dowel)
Be sure to use a wide brim - the tall tower fell over on mine with around 20mm to go.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
