Thingiverse
USB µISP Case
von builttospec
5
Downloads
6
Likes
0
Makes
This is a nice little case for the Geppetto Electronics USB µISP.
It uses 3mm acrylic and 2mm(.08") acrylic.
This case also allows access to the switch on the board.
You can find the instructions here: http://www.built-to-spec.com/blog/usb-microisp-case/
If you don't have a laser cutter, you can grab one of these cases from our store here: http://builttospecstore.storenvy.com/products/13521426-usb-isp-case
Design made by Thingiverse user RoboLemur.
It uses 3mm acrylic and 2mm(.08") acrylic.
This case also allows access to the switch on the board.
You can find the instructions here: http://www.built-to-spec.com/blog/usb-microisp-case/
If you don't have a laser cutter, you can grab one of these cases from our store here: http://builttospecstore.storenvy.com/products/13521426-usb-isp-case
Design made by Thingiverse user RoboLemur.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
