Thingiverse
USB Joystick Controller Case
von jorgepatilawa
6
Downloads
4
Likes
0
Makes
This is is case for a USB joystick controller. I have not tested the dimension so will not be able to confirm the fit. the screw to use on the lid is m3x8. The hole has no tap, self tapping screw would be preferred but normal screw should be no issue (i think). Let me know if there are any issues with the dimension.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
