Thingiverse
usb microscope focus stack
von ekaggrat
854
Downloads
653
Likes
10
Makes
I remodeled the original model to make it much more sleeker and use a lot less plastic.
there are two slide models . depending on the calibration of the printer one is a bit tighter than the other.
you need m2.5 x 6mm x 5 thread inserts to assemble this
also m2.5 x 6mm countersink screws.
there are two slide models . depending on the calibration of the printer one is a bit tighter than the other.
you need m2.5 x 6mm x 5 thread inserts to assemble this
also m2.5 x 6mm countersink screws.
ekaggrat veröffentlicht auch auf
25 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
