Thingiverse
usb microscope focus stack
door ekaggrat
854
Downloads
653
Likes
10
Makes
I remodeled the original model to make it much more sleeker and use a lot less plastic.
there are two slide models . depending on the calibration of the printer one is a bit tighter than the other.
you need m2.5 x 6mm x 5 thread inserts to assemble this
also m2.5 x 6mm countersink screws.
there are two slide models . depending on the calibration of the printer one is a bit tighter than the other.
you need m2.5 x 6mm x 5 thread inserts to assemble this
also m2.5 x 6mm countersink screws.
ekaggrat publiceert ook op
25 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
